The Nini Rose is a product of random creation. It was re-designed and re-designed based on ideas to get a rose named after my wife to express my love for her. This rose aggregation is a big pit, be eclectic. Just explore for yourself when it comes to plastic surgery.
Fold in half on double diagonals, this is a must and is used as a reference line for finishing. It is recommended to use 18cm*18cm large paper.
Divide the left part three times into 2 equal parts and find the 5/8 point on the left.
Same as on the right, find the 3/8 point.
5/8 points overlap and 3/8 points are folded in half.
Expand and return to the previous step, align the intersection points of the vertical lines and fold them in half.
Fold it in half and then fold it in half again.
Fold the bottom 1/4 in half.
Restore it to the image below and fold the smallest square in half.
The unfolded crease. This is the front.
This is the reverse side, gathering the small squares in the middle.
Complete picture (this is different from Kawasaki, but the principle is similar. You can look at this step of PT Rose and feel that it is very similar to PT).
Turn to the front.
Align an edge to an adjacent edge.
Internally flattened.
Complete the drawing on all four sides.
Turn over and tidy up the creases. Align the top corners of the square to smooth them out.
Turn over to the front, position the peak and valley lines as shown in the picture, and repeat on the other three sides.
Complete while doing so.
All four sides are completed.
Group the small squares again.
The inner surface where Yanfeng Valley converges.
Outside.
Prepare to aggregate the second one
Done.
Third.
All four sides are completed.
Then slowly put it away. This step is the most tricky. Practice taking into account both the front and back. There is no requirement to be neat here, just put it away.
Turn to the bottom and find a line like this on one side, which is the intersection of the diagonal line mentioned in the first step and the upper corner. Find this point.
There is no line drawn on the other side.
Make a 45-degree valley fold through the vertex.
After folding, extend the horizontal line as shown in the picture, and fold the upper layer along the edge of the lower layer as a whole.
Get as shown in the picture.
Repeat 3 times for other sides.
Complete the picture.
Front.
Open all the radial top corners and cross peak folds. This part can also be drawn out and re-engraved after the complete finishing. Choose according to your personal habits.
Thats it.
Slightly roll down the flower center and arrange the radiation.
Collapse.
The bottom is folded up as before.
Select a side.
Tani fold.
Back.
Fold the right triangle along the hypotenuse.
Repeat the rest.
Front view.
Turn over to the bottom and find the point shown in the figure. Note that the vertex of the double layer is the point we want to find. . The figure shows the peak and valley line folding.
Done.
Complete the drawing on all four sides.
Complete front view. Start shaping.
