Speaking of which: The pole broke earlier when I was retracting it. Because there is no pole or rope left all the time. In my free time today, I took the broken rod and went to the fishing tackle shop to get some rope. Stop by the Autumn Fishing Gear Show and buy some light bran and short wire drawing powder. So how to reprocess the rod and rope after breaking it? This is the point of this post. I believe many fishing friends have encountered this problem. Especially when tying and unloading the main line, the rod may be slightly broken if not careful. Throw it away? Unfortunately, its only about 4 centimeters too short. Does it match? It also costs money and is not worth it. Then fix it yourself. According to my maintenance concept, I will focus on it below. It would also be helpful to give fishing friends who encounter this problem a reference on how to fix it.
1. Preparation
1. Prepare the rod, rope, glue, plastic tight gloves, small scissors, lighter (windproof kind is better), table Spread old newspapers on the floor. Open the glue head and install the thin tube. The glue I used today is not 502 but real Kung Fu repair glue which is better than 502, plus Gulit AB glue. Because, I think if the rod is slightly exposed to water, I am afraid that the 502 will fall off if it is soaked in water for a long time. Besides, it has a burning sensation and dries quickly, so I'm afraid it will damage the rod, rope and carbon material. That’s why the above two are used. Besides: the new pole I bought before was probably not reliable. I have reinforced the rod with glue or AB glue at the slightest point, and the effect is very good.
2. After cleaning the rod, insert the rod into the rod and test whether the tightness is suitable. If it feels a little tight, thats right. It means that the rod tip and the rod tip are matched. Then move the rod slightly fromPull it out of the rope. If the tightness is not suitable, do not use it. Otherwise, it will fall off when catching fish. The consequences can vary. The loss would be great. It is the principle to be tight rather than loose.
< p align="center">
2. Repair operation
< p>1. First put the rod slightly head down, then apply two drops of glue evenly on the tip of the rod. Immediately insert the rod into the rod rope with finger force. The deeper the insertion, the better.2. Then, tie the pole slightly. I usually stay at least half a meter away. Just cut off the remaining rope and burn the roots with a lighter.
< p align="center">
3. After completing the basics, squeeze a little bit of AB glue and mix it well. First, apply a few drops of glue from the outside to the length of rod rope inserted into it. Also, put a drop of glue on the rope joint of the pole to make it firmer. Finally, rotate the rod slightly to apply AB glue to the rod. By the way, turn the rope and apply glue on it. I think it seals well this way. Even if I soak in the water, I can't get inside. Although the pole rope will be straight after completion, the safety is greatly improved. It does not hinder fishing, throwing rods and catching fish.
Finally:
It should be noted that : The surface of AB glue will turn white after it dries, which will not hinder fishing. Furthermore, do not apply it too thickly, as long as the surface is even. In addition, the distance between the knotting of the rod and the rope must not be too long. At most The distance between a grain of rice is the largest. Otherwise, it is easy for novices to throw the pole and the head of the pole will get entangled. I hope everyone can learn something from this post.
I wish all fishing friends a big crucian carp and a big carp! The platform is getting better and better!
