Materials to be prepared: 1 260 long balloon (any color)
How to hold a Bangbang Bear in hand 1: Use a pump to inflate and tie the 260 long balloon, leaving about four centimeters at the end
2: Twist out a small light bulb at the head of the balloon, and then hold the first balloon.
Twist out another light bulb that is slightly larger than the first one.
3: Then twist out the third one A larger bulb than the second one, and then twist out a bulb that is also larger than the third one.
The three bulbs twisted out from the front must be held tightly with your hands, otherwise they will fall apart. The way to hold them tightly is to clamp each bulb with your fingers
4: Now there are 4 light bulbs. Let’s make the fifth light bulb. The fifth light bulb must be the same as the third light bulb. The bulbs are the same size, remember, the same size, and then twist out the sixth bulb to be the same size as the second bulb.
How to make a long balloon holding a stick bear
5: Twist the second bulb and the tail of the balloon a few times (to form a small circle), the first bulb Leave it out, as shown in the picture below
6: Then move the first light bulb to the middle of the circle Turn to the back, as shown in the picture below
7: Press down on the top of the circle with your hand Light bulbs, twist the left and right bulbs a few times to make bear ears.
Thats it Grasp the bulb and twist it a few times until it is tight, so that the bears face is formed
How to make a long balloon bear with a stick in hand
8: Slowly turn the outward-turned bulb to the front (cut off the excess balloon in the front) and make it small Bears nose!
9: Reserve about 3 centimeters for the balloon under the little bear, and then reserve 3 centimeters Twist the half centimeter in half to make one half that looks like a bow, and do the same as above to make the other half of the bow.
In this way, the stick-holding bear is completed, because the bulb I made for the nose is slightly Its a bit big, so it doesn't look that good. If you want to make it, try to make the bulb on the nose a little smaller, and try to cut the extra balloon as short as possible so that it looks good!
