Illustrated tutorial for folding a rose ring with a ribbon. It can be completed at one time using only one ribbon. If you don’t have a ribbon, you can try it with a long piece of paper and it should be able to be completed~
Get ready ribbons of your favorite color.
Leave about 10 cm on the left side and fold it diagonally upward.
Fold it down.
Stand it up and fold it back using the ribbon on the left as the axis.
The ribbon on the left is wrapped to the right.
Fold the right ribbon back diagonally.
Continue to roll on the left, and repeat the steps just now.
Until the roses are full and beautiful.
After the rose is folded, start folding the ring part like you did with the rose before.
Generally wrap the back twice. The first circle is lower than the bud, for the sake of beauty; the second circle is close to the left ribbon to fix it and prevent it from loosening.
Tie a knot when done. If its not loose at the back, no glue is needed at all.
Loop the ribbon around your finger and tie it into a knot.
Wrap the ribbons on both sides upwards.
After wrapping it, tie a tight knot under the rose and cut off the excess ribbon.
The rose ring is folded.
You can put it on your finger and try it out.
When fixing the rose in the end, try to make it as tight as possible. If you are not worried, just apply some glue~
