Womens beautiful romantic atmosphere and exquisite craftsmanship interpret a low-key and luxurious life attitude. The perfect design style meets the new needs of modern women and adds to a romantic and elegant life. color. Each bag is a magical accessory that perfectly reflects the personality and temperament of a mature woman.
Production steps
1 First put some pictures of the finished product to make up the word count
Finished product renderings.
Finished product renderings.
Finished product renderings.
Finished product renderings.
6 Step 1: Cutting materials 1. Front panel, back panel, and back pocket: one piece each, with size 15×10cm2, front pocket: one piece, size 15×8.5cm3 , Side panel upper circumference: 27×5cm (the length was shortened in the end, because there was no drawing, so it was adjusted while making, and it was adjusted according to the overall number of holes) 4. Side panel lower circumference: 27×5cm 5. Flip cover: top Width 13, bottom width 11, height 11cm (note that the front and back have been pasted with leather before cutting) 6. Piping: Leave a length of 55×3cm (same as above, cut shorter at the back) 7. Wrist strap: 1.2cm wide, length It depends on personal preference (same as flip cover, already attached to the skin and then cut). The position of the four-button buckle is determined while doing it. It is recommended that you draw the drawing in advance and install it directly in this step
7 Step 2: Thin and paste (1) 1. Thin the uppermost part of the front bag by 2cm. 2. Thin the two short sides of the lower side panel by 2cm.
8 Step 2: Thinning and pasting (2)
9 Step 3: Partial stitching: Sew the modules that need to be stitched separately first.
10 Part 4: When positioning and drilling holes, pay attention to the details of the number of holes. 1. The number of holes on the upper and lower sides of the side panels must be consistent. 2. The back panel and the back pocket should fit together. Make holes 3. The number of holes on each edge of the back panel, back pocket, and front panel is the same. 4. The number of holes on the unsewed side of the flap and the number of holes on the back panel + the hole above the zipper of the back pocket are consistent. 5. The bottom of the front bag The number of holes on the sides and the bottom of the back panel/front panel/back pocket should be the same, and the short sides on both sides need to be symmetrical. 6. Add the number of holes on the four sides of the back panel/front panel/back pocket and add 2, which equals that the upper and lower sides of the side panels are separate. Add the number of holes on one long side to 7, add the number of holes on the back panel/front panel/back pocket and add 4, which equals the number of piping holes: 8. The number of holes for fixing the wrist strap to the lower side of the side panel must be symmetrical and consistent. Its complicated, but you can actually understand it if you think about it. The purpose is to sew them together for a good effect. It is recommended to gather them all in the center and position them at both ends to pierce them.
11 Step 5 Partial assembly Note that the back panel and back pocket are sewn to the flap at the same time, because the leather is very soft and thin, in order to increase the support.
As shown in the figure.
13 Step 6: The overall stitching method of piping and overall stitching is as shown in the figure.
After 14 stitches, trim off the excess piping (if you want to make it more refined, you can add hemming, lining, etc.)
15 Step 7: Complete the overall splicing and then turn it over firmly.
As shown in the picture.
