I recommend it because of my habit I cut leather with a knife, so I bought a Blanchard half-round knife. The diameter of the blade of this knife is 125mm, so it is easy to be accidentally cut. In addition, I love tools, so I made a tailor-made coat for it.
Tools and materials required: leather knife, diamond pliers, pill needle, edge polishing wax, bed surface treatment agent, sanding rod, rivets, semi-vegetable tanned leather, Japanese 3-strand nylon thread.
Production steps:
1 Selected 2.0mm semi-vegetable tanning. Press the template on the leather surface and draw lines. Because the two sides of the blade are not equal, draw a piece on the front and back; then roughly cut out the leather.
2 Paint the back Apply bed surface treatment agent and use a sanding rod to go back and forthRub until smooth.
3 Cutting leather , if you are not good at cutting the inner arc, you can cut it bit by bit.
4 is polishing Use an edger to trim the corners before.
5 Because it is The inner arc cannot be polished with a polishing strip, so I used a straight pen wrapped with a circle of sandpaper to polish it back and forth.
6 Use the edge device to press the edge line. It is very difficult to press the edge line in the inner arc, so it must be done slowly and steadily.
7 beds Use surface treatment agent to polish the edges that have been sanded with sandpaper again.
8 Apply Edging wax, then polish with cotton cloth.
9 on the edge Put a layer of 1.2 thickLeather to protect the blade.
10 two pieces Skin-to-skin bonding.
11 Polish the edges , the polishing sequence is to polish the cut surface first, and then use the polishing strip to polish the edge at a 45-degree angle to create an arc. After sanding, use bed surface treatment agent to make it smooth.
12 Reuse Rub the edge with wax several times and finally polish with cotton cloth.
13 Oops! I forgot the seal. Fortunately, this is a knife sheath. I have an idea; I put a small piece of cutting board in the middle so that there will be no marks on the other side. .
14 Mine Exclusive items have this seal.
15 Border device After drawing the line, use diamond pliers or diamond choppers to punch holes along the line.
16 I use green Japanese 3-strand nylon thread, the thread thickness is about 0.6mm.
17 Sew Then two rivets were driven on both ends.
18 Don’t worry about the knife holster slipping off easily. The clamping force between the two pieces of leather is enough to ensure that the knife holster will not fall off when you lift it vertically. It is also very convenient to take.
