The production process of business short clip

1. Skin It is made of blue tiger stripe dyed vegetable tanned 1.6mm, with different shades of electric blue lines and tight leather. The inner skin is made of French orange Cherve Sully goatskin with a thickness of 0.5mm

2. First fit the outer skin of the short clip. The wallet needs to be bent and curved surfaces need to be bonded when sticking it together.

3. Use Place a margin wheel of appropriate inner diameter against a ruler and draw the area to apply glue on the outer skin

4. Reserve 2-3mm for the orange goatskin part of the inner leather and then use the margin wheel to draw the same glued area

5. The red area is where glue needs to be applied as much as possible Apply the film pattern evenly and neatly

6. Try not to use resinous yellow glue. It is better to use water-based white glue for thin coating

7. Paste the left and right sides of the inner and outer skin against the previously drawn reserved line, and the left and right sides must be aligned.

8. Alignment Then do the curved surface bonding

9. After pasting, use a paring knife to cut off the left and right remaining skin and then paste them together

10. Next, the method of attaching the inner banknote position is the same as above. Note that this time, do not leave any margin when pasting it

11. Since the goatskin here is The inner side of the banknote is curved inward. The sheepskin is soft, thin and has a certain stretch. Even if it is the same size as the opposite skin, it can have a curved surface bending effect

12. Steps of pasting. Don't forget to use the roller to compact it after pasting.

13. After the inner and outer skins are attached, start making the clipping part. Press the decorative line before doing edge sealing on the card position. Need to use: water sandpaper 600-1000 and the most important colored edge sealing fluid (black)

14. Use a cotton swab dipped in water to apply to the edge and then sand it with about 1000 grit sandpaper

15. Apply black edge sealing liquid to the edge of the leather after grinding, and the edge sealing can be done in one go

16. Card position leather After the edges are processed, prepare to assemble the card slot part

17. Use a thinning knife to thin the overlapping portion of the upper leather block to reduce the overlapping thickness

18. Draw the card area on the sheepskin. The upper skin barrier is completely attached to the sheepskin

19. Assemble the card position normally. Here is a little tip, use 2mm wide double-sided tape to fix the lower card position

20. Start aligning and pasting

21. Use the edger to measure 3mm Make a cut line on the front of the card position to exactly exceed the 2mm double-sided adhesive area

22. In this way, the double-sided tape seam will not be poked and the needle will pass smoothly

23. Cut off the excess part to release the two card slots

24. Next, pair the two card slots one by one Polishing

25. Then press the seam with the decorative line to seal the edge

26. Use a round-tipped stylus to draw 4 card installation points on the inner banknote

27. Two points on the lower side Before installing the card slots, the decorative lines must be sewn and pressed and the edges must be sealed

28. Use an edger to draw the gluing area between the fixed card installation points. After drawing, use a triangular sanding tool to roughen the leather surface

29. Use an iron ruler to hold this step It is appropriate to be regular

30. The pasted outer skin & inner clamping part. Finally, the inner and outer parts are combined together

31. The edge sealing method is the same as above, or you can use edge oil to seal the edges. Let’s share a waxing technique after sealing the edges

32. Cut the black Columbus Temple edge-sealing wax into powder, iron it on cotton cloth, and rub it on the leather edge

33. The last step is completed

Complete effect

There is also a brown and black British-made JE harness material package available

Brown harness matches Italian Vegetable Tanning Association mbox soft vegetable tanning effect

The black harness can be paired with orange French goatskin or black mbox

There is also blueColor camouflage short clip material package for sale Author: MOVE_Yao Yang Taobao store: https://shop127309944.taobao.com

Short clip