Illustrated tutorial for DIY handmade power car toys with rubber bands and CDs

To share with you today One of the tutorials is a manual DIY power car tutorial using rubber bands and CDs. With the help of the elasticity of the rubber bands, you can really run! Children who like this kind of small technological production, come and follow the tutorial below!

Material: plastic wrap tube, disposable chopsticks, CD disc, wooden buttons, buttons, straws, rubber bands, paper clips, hot glue gun, scissors, hole punch, white craft glue, paint (optional).

In the center of the CD Stick a wooden buckle on one side

Adhere the button on the other side

Prepare four CDs , are treated in this way

In the plastic wrap tube punch a hole in one end

Then put on the rubber band and punch the other three holes in alignment

Disposable chopstick cutting into a suitable length, insert it into the hole of the plastic wrap tube, and use it as a tire pump.

The straws are also cut into suitable length

Disposable on chopsticks

Then install the tires made of discs

Four tires The method is the same, but note that the axles of the two rear tires are longer.

Tire installation method , is to add glue to the wooden buckle

Then start using rubber bands makePower unit

Put the rubber band on the front on the wheels axis

As shown in the picture above Hold the tire axle

Tighten

Hook the other end of the rubber band with a paper clip

The rubber bands should be as long as possible Some, at least there is still something left through the plastic wrap tube.

Paper clip with rubber band Pass through the plastic wrap tube and come out from the rear wheel opening

Clip with paper clips Plastic wrap tube

This power unit does not need to be connected to the rear wheel

Then you can turn For the front wheel, wrap the rubber band around it to accumulate power
Let go of the front tire and this car will start running.