Home > Creative handicrafts > jewelry diy

DIY metal cap shaped mandala tassel necklace

DIY metal cap shaped mandala tassel necklace

Shared today This DIY metal necklace tutorial, I hope you like it.
1. Use the central circular grid printing guide in the blank and fix it on the stamping block.
Tip: Make sure the stamping block has a hard, solid surface.

DIY metal cap shaped mandala tassel necklace

2. Total is the beginning of the mandala pattern in the center and outer

DIY metal cap shaped mandala tassel necklace

3. In Brilliant patterns are printed on both sides of the diamond mark, in the middle and between the first small black circle grid mark.

DIY metal cap shaped mandala tassel necklace

4. Print a simple design in the middle of the first and second black circle grid marks.

DIY metal cap shaped mandala tassel necklace

5. Use Second black circle grid mark

DIY metal cap shaped mandala tassel necklace

6. A diamond pattern is engraved between the third and fourth black circle check marks.

DIY metal cap shaped mandala tassel necklace

7. Continue to draw the pattern

DIY metal cap shaped mandala tassel necklace

8. Use The punching pliers punch three holes in the stamping blank - the upper left corner, the upper right corner and the bottom corner

DIY metal cap shaped mandala tassel necklace

9. Graffiti , wipe off after 3-5 minutes

DIY metal cap shaped mandala tassel necklace

10. Use Two pliers, one for each hand, for the twisting and separating methodSlide the base of the blank and fringe onto the jump ring. Use pull to twist the jump loop to close.

DIY metal cap shaped mandala tassel necklace

11. Use a flat cutter to cut the 30-inch premade chain in half. Attach the chains to the upper left and upper right using chain pliers and jump rings.

DIY metal cap shaped mandala tassel necklace

DIY metal cap shaped mandala tassel necklace

The DIY metal necklace is finally completed.