Tutorial on how to DIY a fresh ring from iron wire. Using common thin iron wire, with a little creativity, you can DIY a cute ring as shown above. Little girls will definitely like it! The characteristic of this wire ring is that it is small and cute. For specific ring DIY methods, please refer to the illustrated tutorial below.
Main materials:
2 rolls of thin wire (silver, red, of course you can choose your own), 1 lipstick
Production steps:
Step 1:
The materials are very simple~
Step 2:
Take a silver wire and a red wire, about 20cm long, and twist the two wires together. Don't twist them too tightly, just twist them slightly.
Step 3:
Find a cylinder about the same thickness as your finger, lipCream would be the most suitable choice.
Step 4:
Place the lipstick in the middle of the wire. Wrap the lipstick around the two ends of the wire twice.
Step 5:
First, twist a knot in the middle of the wire, take off the ring ring and put it on your finger to test the size.
Step 6:
Start twisting the shape. Put the ring ring back on the lipstick, as shown in the picture above, the two rings will start to rotate and coil up to look like a flower.
Step 7:
After you feel that the size of the flower is suitable, cut off the excess wire, leaving only about 1cm of length at both ends.
Step 8:
Wrap the wire left at both ends around the rings on both sides of the flower.
Step 9:
A delicate small ring is ready. Use the same method to twist out a smaller silver ring. Isn’t it special to wear two pieces together?
