You must have played with rubber bands when you were a child. Have you ever thought about making it into a ring? You don’t just put it on your finger randomly, but you need to use props to knit several rubber bands together. , and finally made a super beautiful flower-shaped ring!~
Materials and tools: rubber bands, C-buckles, hooks, braiding frames.
Put the rubber band on the braiding frame as shown above.
Then put the rubber band in the lower left corner in front.
Put a rubber band on once, then put on a rubber band that has been wrapped twice.
Hook the top rubber band into the corresponding position.
After hooking it up, it looks like this, with a large space in the middle.
Thread the rubber band, find the bottom rubber band, and hook it to the left.
Same as above, tick to the front.
Sequence diagram for hooking rubber bands.
< /p>
Prepare a rubber band and put the hook through the rubber band to hook it.
Hook up the rubber band and put the other half on the hook.
Remove the rubber band.
Put on two more rubber bands and put on the C buckle.
Find the corresponding position, pass the hook through it, and hook it with a rubber band.
Put the other half through the hook.
Put on two more rubber bands and put on the C buckle.
The ring made of rubber bands is finished. It is still a bit difficult. The key is whether you can sort out the clues and grasp the key points~
