Disposable lighter DIY motorcycle model

Teach you how to DIY a motorcycle model from a used disposable lighter. If you smoke at home, you can collect a few discarded lighters and give it a try. Please pay attention to safety. For specific DIY methods, please refer to the graphic tutorials and video explanations below.

Main materials:

2 lighters

Tools required:

Latex, scissors, ruler, utility knife, brush, sandpaper, pliers

Production steps:

Step 1:

First, prepare two lighters of the same size

Step 2:

Let go of the gas and carefully disassemble it, and you will find so many small parts~

Step 3:

Just leave these parts. Comparing them with the paper model above can make it easier to understand the combination of each part.

Step 4:

First wrap the metal rod with double-sided tape, then put on the cap and set aside. This will eventually become the exhaust pipe

Step 5:

This step is very important. First put the buttons on the pole of the left base, then clamp the right base as shown in the picture, then put the right buttons on, and finally use the right buttons to clamp the holes on the pole of the right base

Step 6:

Compared with the model, this is the body of the heavy machine

Step 7:

Then put a small spring on the oil-absorbing pole and pass it through the hole on the right base pole, then put a small spring on it, and finally put on another handle, set aside a small section, cut it off, and bake it with fire to fix it. The faucet is completed

Step 8:

Wrap the exhaust pipe you just prepared with an appropriate amount of double-sided tape, insert it into the gap in the left base, and install the tires and front. The mini motorcycle is about 70%-80% complete

Step 9:

Compared with the model, all that is left is the final decoration. Here everyone can use their creativity to create their own style of heavy machinery

Step 10:

This is a new machine that has been decorated with rearview mirrors, fuel caps, fuel tanks, exhausts, etc. suggested by netizens for your reference~

Step 11:

Close-up of each part~~~

Step 12:

Let’s take a group photo. Isn’t it amazing? The DIY motorcycle model made with a lighter is quite cool!