1. Group binding method: Some wild flowers and plants have bright and attractive colors, but the flowers are very small. One or two branches of flowers cannot reflect the beauty. The good effect can only be revealed when they are gathered together. Therefore, when arranging flowers, you can hold the flowers into a ball, tie them with ropes or wires, and then insert them.
2. Flower socket conjoined method: The size of the flower socket is limited. Sometimes, in order to make a large flower arrangement, one flower socket alone is not enough. In order to arrange more flowers, you can put several flower arrangements together and fasten them with several small branches.
3. Flower arrangement upside down method: When using woody flowers to arrange flowers, it is inevitable that the flower branches are heavy and the flower sockets are light, causing lodging. At this time, you can buckle another flower socket on one side of the flower socket to increase gravity.
4. Metal wire wrapping and entanglement method: In order to support certain flower branches and overcome defects in flower shape, flowers can be shaped into a spiral climbing style. Use a metal wire that is hard enough to bend the branches into shape around the entangled branches, and bend them according to your own ideas. However, the metal wire should not be too thick, and it should not affect the ornamental effect of the flower arrangement. If necessary, you can wrap a layer of green tissue paper on the wire or apply green paint. Using this method, you can make the bending of the flower branches change freely and do whatever you want. This method is suitable for treating soft flower branches. 
5. Metal wire threading method: The center of the flower stalk of some flowers is hollow, such as marigolds, celery flowers, and gerbera flowers. You can choose metal wires of moderate thickness. Insert it through the incision, or you can insert it from the center of the stamen. This method will not affect the appearance of the flower branches, and can make the flower branches bend freely. However, this method cannot be used for non-hollow flower branches, such as carnations, chrysanthemums, etc. During the process of threading the metal wire, if it is difficult to penetrate the upper part of the flower branch and the part near the flower, it should be based on the specific situation, or it should be done in moderation, not completely penetrating the flower branch, or it should be partially threaded and partially wrapped.
6. Wedge shaping method: For thick and hard woody flowers, in order to achieve the natural curved beauty without revealing artificial traces, triangular wedges can be used and set into the incisions of the branches to be shaped. . Wedges are required to be made of the same kind of plant material. The thickness and size should also be basically the same. The flower school made in this way has a soft shape, is pleasing to the eye, is generally very embarrassing, and does not affect the branches' absorption of water.
7. Incision bending technique: The bending angle required for woody flower technique is not large. You can also use scissors to cut the flower stem diagonally. The depth of the incision should not exceed 2/3 of the diameter of the flower stem, and then hold it tightly with both hands. On both sides of the cut, slowly bend the branches. If the branches are tough, small wood chips can be inserted into the incisions.
8. Leaf curling method: Some flowers, such as Ruo leaves and calliope, can change their original shape by curling. The method is to flatten a leaf, use a thin stick to roll the leaf from the tip to the stem, pull out the thin stick, and rub it repeatedly until you let go and the leaf still has a certain curl. If you want to express a spiral shape, you can roll the leaves diagonally, and then they will become spiral shaped.
