DIY straw weaving beautiful shrimp jewelry pendant handmade method; very beautiful, this is using the ones we usually usestraw is made, its detailed steps are here.
The color and photo of the straws in these two pictures are more impressive. The transparent ones look more realistic and beautiful.
1. Take a complete straw with a curved pipe, cut it from the end far away from the curved pipe, and cut it into three strips of equal width.
2. Pass one of the strips through as shown below and tighten it.
3. Wear the other side in the same way and tighten it similarly.
4. Fold one of the two crossed pieces upwards and vertically.
5. Fold the upward fold forward (about 45 degrees) to make a corner, as shown in the picture below.
6. Take the twice-folded strip and pass it through the middle strip according to the method in the second step.
7. The same is true for the other side. After it is put on, the second body section of the shrimp is ready.
8. Make the third section of shrimp body according to the above method.
9. After the three body sections are completed, leave three or four centimeters and cut off the excess straw part.
10. Cut the wide strips on each side into four narrow strips to serve as shrimp legs.
11. Fold the cut shrimp legs as shown below.
12. Making shrimp tails is much simpler.Cut 1CM away from the elbow as shown below.
13. After cutting, press lightly.
14. The prototype of the shrimp is basically formed, and there is still the final step. Cut two thin strips from both sides of the wide strip in the middle (as thin as possible without cutting) to serve as shrimp tentacles. Cut off the excess part in the middle (leaving about 1.5CM), and then cut it from the middle. .
15. A beautiful shrimp wine is finished, it’s quite beautiful!
