DIY Straw Weaving Beautiful Shrimp Ornament Pendant Handmade Method

It’s very beautiful. It’s made using the straws we usually use. Here are the detailed steps.

The colors and photos of the straws in these two pictures are more striking. The transparent ones look more realistic and beautiful.

1. Take a complete straw with a bend, cut it from the end far away from the bend, and cut it into three strips of equal width.

2 , pass one of them through as shown below and tighten it.

3. Wear the other side in the same way and tighten it in the same way.

4. Fold one of the two crossed pieces vertically upward.

5. Fold the upward fold forward (about 45 degrees) to make a corner, as shown below .

6. Take the twice-folded strip and pass it through the middle strip according to the method in step 2.

7. The same is true for the other side. After it is put on, the second body section of the shrimp is ready.

8. Make the third section of shrimp body according to the above method.

9. After the three-section body is completed, leave three or four centimeters and cut off the excess straw part.

10. Cut the wide strips on each side into four narrow strips to serve as shrimp legs.

11 . Fold the cut shrimp legs as shown below.

12. Making the shrimp tail is much simpler. Cut it 1CM away from the elbow as shown below.

13. After cutting, press gently.

14. The embryonic shape of the shrimp is basically formed, and there is the last step. Cut out two wide strips in the middle from both sides. Thin strips (as thin as possible without cutting them) are used as shrimp tentacles. Cut off the excess part in the middle (leaving about 1.5CM), and then cut it in the middle.

15. A beautiful shrimp wine is finished, it’s quite beautiful!