If you are a novice in rubber stamp making, you may not have such trouble, because the rubber stamps you make should be relatively simple. However, as you understand and deepen the rubber stamp making, you will You will have more ideas and requirements for the production of rubber stamps. For example, because of the characteristics of a rubber stamp, that is, it is a whole, so when we print the rubber stamp, it is difficult to put different colors on this rubber stamp, so if you want to make a The effect of color registration will be more difficult. However, it is not unrealistic to get the customized effect of a colored rubber stamp. Here we will use a very simple rubber stamp production to tell you the principle of making a colored rubber stamp!
Step 1:
In order to get different colors, we need to prepare three parts. The first one is naturally the whole, and the rest must be printed. Different colors
Step 2:
Start the transfer below
Step 3:
Successfully transferred to the rubber brick
p>Step 4:
Now you are ready to start engraving rubber stamps
Step 5:
First cut these three parts to facilitate engraving
< p>Step 6:Starting from the largest one, carve out the middle part of the puppys paw pad
Step 7:
Just dig it out like this That’s it
Step 8:
Isn’t it quite easy?
Step 9:
The inner edge of the large part below needs to be Carve a groove
Step 10:
This is the effect
Step 11:
Then prepare to leave White
Step 12:
Change the middleLeave some parts blank
Step 13:
Continue making again
Step 14:
The side parts also need to be carved< /p>
Step 15:
Engraved
Step 16:
The blank part uses flat blank
Step 17:
Cut off the excess edges
Step 18:
The other two are also done
Step 19:
When printing a rubber stamp, print the largest overall part first
Step 20:
Then print the second one in orange
Step 21:
After the last one is printed, there is a color registration The rubber stamp puppy paw effect!After watching the production of this puppy paw colored rubber stamp, are you suddenly enlightened? Although making a colored rubber stamp is a little more complicated, because we need to make it according to different colors. Different parts are made and finally combined together to produce a colorful effect when printing. However, if you want to get a uniform effect when customizing rubber stamps, it is better to use the color registration method instead of using How to color.