In the past, when we made rubber stamps, the first step was to print our materials on the rubber. If it is a relatively simple pattern, then we can draw it with a pencil on the sulfuric acid paper, and then print it on the rubber brick with force, so that as many pencil lines as possible are transferred to the rubber, so that we can proceed further The rubber stamp has been produced, but what if the pattern we need is very complicated? Then we can't just draw it with pencil lines one by one, and then transfer them to the eraser. Here is an iron-assisted method to help us transfer large-length materials to rubber bricks.
Step 1:
This pattern is quite complicated, so prepare some toilet water
Step 2:
Spray toilet water on the rubber
Step 3:
Then stick the material paper on top of the rubber stamp, wet it all with toilet water, and then start ironing it with an iron
Step 4:
Then you can take off the paper. It doesn’t matter if there is some paper stuck on it, just wash it.
Step 5:
p>
After reading this method, are you very excited? Because with this method we You will no longer worry about the pattern being too complicated and unable to draw it by hand. It can be said that this is also a very common method of transferring rubber stamp materials. I hope everyone can master it smoothly.
