Home > Handicrafts of life > Small craftsmanship

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

1. In fact, everyone has different preferences for flowers. The petals of the wedding car front flower below are 3.8 wide ribbons and 9CM in length, a total of 15 petals. Burn both ends of the ribbon with fire and trim the edges to avoid snagging. Be careful not to burn your hands when burning.

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

2. Take one of the ribbons (3.8 wide, 9CM long)

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

3. Fold in half

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

4. Unfold the ribbon and fold a triangle at one end of the ribbon as shown

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

5. Fold the sharp corners of the triangle in half along the center line, as shown in the picture:

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

6. Use a flat stitch to sew halfway through the inner thread of the ribbon. Then fold the ribbon at the other end according to steps 4 and 5, and temporarily fix it with another heel pin, as shown in the picture:

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

7. Take another ribbon, repeat steps 4 and 5, overlap it with the right half, and sew with a flat stitch On the inside of the ribbon to the centerline.

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

8. Use the same method to sew the rest to item 14

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

9. Use the last strip to make the flower core and sew it separately.

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

10. Sewn flowers The core is folded on one side and smooth on the other. The smooth side is used as the inner side. Roll it inward from one end to form the flower core you want.

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

11. Roll the 14 sewn petals along the core of the flower, and apply glue while rolling (children who are good at needlework can use sewing, hehe). When applying glue, pay attention to the seams and not apply too much.

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

12. The picture below is a rolled flower. The petals are 4CM in diameter and the ribbon is 0.9 in width. The length depends on personal preference. Mine is about 40CM in length.

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

13 . 0.9 fold the ribbon and glue it to the center of the bottom of the flower.

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

14. Pass the ribbon through the hole at the top of the suction cup and come out from the holes on both sides. Apply glue in one roll along the top of the suction cup to make it stronger.

A simple illustrated tutorial on how to DIY the flowery front of a wedding car

15. Roll the ribbon around the top of the suction cup, tie it into a tight knot, and then tie it with a bow. Then beautiful flowers will appear.

A simple illustrated tutorial on how to DIY the flowery front of a wedding car