How to make a tool tray, Tianjin Lao Zhang version

Under the guidance of Dr. Man, a tool veteran from the "Leather Craftsmen 2 Group", I finally ordered a few commonly used tools from the owner of the Hunting Workshop, breaking the stinginess of cheap tools in the past. So I wanted to make a container for storage on a whim. Then I thought about it. Since I insist on doing my best by hand, I actually use very few tools, so I finally decided to make a tray to put everything on it for easy handling. The specific method is as follows: First order a wooden board, black walnut, about 50*30*1cm in size

Then grind the front side like this, and invert the corners a little

This is what it looks like from the side

Then this is where I plan to place it

At this time, start drawing the paper shape, first draw the square to determine the position

Then draw the desired arc< p style="text-align: center;">

About this ratio

Press a piece of dark green material according to the paper shape I forgot to take pictures, and then I planned to make a crossbite. I made this very thin, about 1.8mm into 0.4mm

The method is the same, sew this time first

Then turn over like this

Let’s take a closer look at the corner

Then remove the middle position

Then start making the core

I was a movie at that time From this perspective, it depends on your personal preferences

This is when you are halfway done. Note that the two ends of the upper strip are bulging, ready to be used for setting the blade

Then I covered these two cores.