LOEWE Gate handbag, a light explanation of the production process

This article is reproduced from the kraft paper drawing of LOEWE Gate handbag purchased from Yuge Style House http://www.exiaodian.com/go/254

A light explanation of the production process: 1. Side panel 1. The rough-cut outer skin is first bonded to the bran paper and then fine-cut. (You can try using BOX leather or Tallinn paper as support here)

2. Bevel as shown in the figure after fine cutting (if a 1.5 thick leather outer ring is used, it can also be appropriately thinned)

3. After roughly cutting the flannel (lining) according to the pattern, match the ones prepared in the picture above The side panels are fitted and then tailored

4. Apply edge oil to the areas where the side panels can be oiled separately

2. Front panel 1. Glue the rough cut of the front panel leather, leather bran paper and lining cloth and then finely cut it. After cutting, follow the pattern Drill the beheading hole, oil on all sides (front)

(Back)

3. Connection of front and rear side panels 1. Slope at both ends of the connection, and the width of the slope should not exceed the setting limit line

2. Align and glue according to the layout position

< img src="https://img.111diy.com/timthumb.php?src=/d/file/fujian/eaaf49683e3bc3f811eb0b223323f87d.jpg" alt="">

3. Drill all the cut holes

4. Sew as shown

4. Sewing the front side panel and front panel 1 , Sew the front side panel to the front panel according to the hole position of the pattern, no need to glue

5. Straps + back pockets 1. The start and end of the strap stitches are as shown in the picture (the positioning holes are the holes framed by the circles on the pattern) PS: The shoulder straps are made according to the "shoulder straps" Just do it with reference version

2. The straps here need to be cut according to the pattern and left for later use

3. Insert the back pocket, rough cut the leather + lining, then finely cut, cut the holes according to the pattern

4. Sewing the back panel and straps, here All are individually oiled. For stitch alignment, please refer to the cutting position of the circle frame on the pattern

5. The sewing process is as shown in the picture

6. Hijab (rear panel with cover) 1. Sewing the hijab and the hijab splicing piece (no base material is attached here)

2. Cut the base material roughly and glue it together. Tailored

3. Sutures as shown in the figure

4. Connect the hijab splicing parts as shown in the figure Back side panel stitching

5. After fitting the back pocket, sew the entire hijab line

7. Middle compartment zipper bag (the 20 is a slip pocket, pay attention to the distinction) 1. The lining and leather bran paper are bonded and tailored

2. Cut out two separate pieces Individual lining

3. Make the zipper according to the zipper positioning line on the pattern

4. Glue in sequence as shown in the figure

5. Sewing the bag mouth

6. Use a die to punch holes on the left and right sides , stitching (here, the two layers are directly punched through, and then the two layers are stitched together)

8. Cover (back panel with cover) + front panel 1. Sew as shown

2. Cut the leather binding of the pen barrel according to the pattern as shown (both front and back)

9. Overall suture 1. Front, center and back After sewing, seal the edges

2. Set the straps as before hole, tighten the knot to the most appropriate position (control it yourself), and sew according to the hole

10. Finished product

Luo Yiwei