Knight mask production process

From "a certain Leather Goods Zhilian has been pushing motorcycle masks for 5 days, I will give them away Drawings.” I got the drawings for this post, and I’ll post the production process below. http://www.pixiaojiang.com/topic/show/734 Cut the leather according to the pattern, and then use an awl to nail the marks according to the holes in the pattern. It is recommended to use hard leather of about 2.5. If you want to wear it, it is recommended to use vegetable tanned leather. Other leather types contain heavy metals, which are not good for inhalation.

Punch holes, I didn’t buy a row of punches. I used a 1.5 punch to hit them one by one. I was exhausted. I used a 5mm punch for the big holes. There should be air holes installed in the big holes, but I didn't have enough air holes, so I didn't install them. It is recommended to use 5mm air eye and use 300 model air eye tool.

Like this After assembly, every hole can be matched. Thanks again to the leather craftsman for his precise pattern.

Start sewing, The thick flat wax thread used is cheap, strong and rough in style. I added a leftover zipper from making a bag. It’s so short that it’s useless. Adding it to add a metallic feel is also a waste reuse.

Upper stitching< p style="text-align: center;">

Sewing of edge strips

After finishing it, I did not make a headband, but used two pieces of leather strips on both sides to hang on the ears

World War II pilots broke in