< /p>Carry out the second cutting for further refinement
The benefits of accurate cutting will be very obvious, and vertical cutting will also be beneficial to subsequent stepsThin the bottom and sides of the card slot to avoid being too heavy after installing the cardChoose the appropriate type of chamfer according to the thickness Tool Edge trimming You need to pay attention to maintaining a fixed angle so that the edges will be consistent Use sandpaper + water for polishing. There is no need for leveling here. , starting from 1000 meshAfter polishing, apply edge sealing liquid and wait for dryUse a shaping rod or other sanding rod to polish (you can polish with cotton cloth at the end)Before combining the card positions, sand the parts to be pasted roughly to facilitate adhesionGlue bondingSince there will be a seam in the middle, Therefore, cut the two sections at the bottom of the card positionThe line on the inside of the card position needs to be smoother, so 3 strands of 0.45 nylon line are selected here. After completing the hammer line,There will be no protruding lines
< /p>The stitching inside the card position does not require the stitching technique, as long as it is neat and unified
Cut off the excess linesAfter burning, use a lighter to flatten it on the sideBefore the hammer line (hammer line is a very important step, which can make the line protruding from the leather surface very smooth ) Hammer line AfterCombined During the process, be sure to pay attention to accuracy and minimize the gaps between the card positions, which is beneficial to the appearanceComplete the stitching of the middle part(Please use the same line as the periphery here)Adhere the clips on both sides to the outer skinCustomize the excess partsThe cutting must be careful, it must be flush, and the knife must be sharp Flush is very, very, very important for subsequent edge sealing (or edge oiling) processing Make a straight line The most basic requirement (2 photos are lost here due to a bug, so there is no other way), then sew, and then determine whether to make edges according to your own preferences, and then seal the edges to completeOutside pictureInner pictureTips for details: Students who like to do things can start trying to make them. In fact, the difficulty is similar to the short clip, but because it is larger, the consequences of being disabled are more tragic, and you need to be more careful
Long clip