Red leather backpack diy handmade steps

Author: Yijiang Studio, Weibo: https://weibo.com/margueriteqqq

1. Cut the kraft paper and apply oil

2. The bottom part of the package is a rectangle, with two ends of one of the long sides rounded and cut around, as used here The one is 4mm pitch.

3. Cut Cut a pair of "ears", insert D-shaped rings, fix them with four sets of I-shaped nails, and use white glue to fix them.

4. Package Back part. There is a lot of leather in this part, including the bag cover, document bag, handle, two straps, two bag buckles, and strap reinforcement leather. It needs to be cut, marked, cut, and chopped separately, and some edges are still You need to use the bed surface to seal the edges, which is a job that requires patience~

5. Sew the document bag and bag back leather.

6. The production of strap reinforcement leather. Need to use round Kong Chong, one word chop.

7. Rub the sides of the strap, yes, rub it hard and fast with high frequency...

8. Use white glue to stick the schoolbag handle and strap. The bonding area needs to be sanded with sandpaper to make the surface rough, so that the bonding will be stronger.

9. Pass through the strap to reinforce the leather and use Fix with white glue and I-shaped nails.

10. Sew the strap to strengthen the leather.

11. Sew covered buttons.

12. Connect and sew the bottom and back of the bag.

13. Sliding lock buckle and bag back For the steps of connecting the buckle, the sliding lock buckle part requires nailing and corresponding nailing punch.

14. The back connection buckle needs to be fixed with I-shaped nails.

15. In-seam pocket

16. The essential thing for making your own bag is to emboss your own hot stamping logo. Here, a hot stamping machine is used and the temperature is adjusted to 120.

17. Decorative leather strips on the outside of the bag, Be sure to calculate the cutting position.

18. For the corresponding interior, attach the inner bag to the sandwich between the bag body and the inner supporting leather, and sew.

19. Its the side rubbing again, yes, high frequency, fast and hard...

20. Install the sliding lock buckle to the bag body, pay attention to the corresponding bag cover buckle The corresponding spacing.

21. Sew the back and body of the bag.

22. Use flat-nose pliers to pinch the suture tightly.

23. Repeat the rubbing and edge-rolling operations three to five times in sequence.

24. Install and assemble the slide lock pin buckle.

25. Do the package type Fine-tune it and its fine.

Tips: Many friends say I can't make it as neat as the picture when I operate it. In fact, more than half of the neatness of the backpack after it is finished depends on whether the leather cutting and cutting position calculations are accurate. You must have enough patience in these two steps to achieve the best results. Get twice the result with half the effort~

Backpack