Author: bob Original text: http://www.sogoke.com/r/17488/
Based on the 42mm Apple Watch, the hand-stitched leather strap is made with a very detailed production process. The tutorial does not explain the basic knowledge in detail, because there are many excellent leather basic introductory tutorials in the kinii community in the early days. Detailed preparation steps for production:
< /p>Any design basically starts with design. The more accurate the drawing, the better the result will be. Because I was making a relatively simple model, I drew a sketch by hand.
Apple watch strap hardware , and the cut paper pattern.
Continue to improve the pattern , including folding lines, hole positions, etc. The more fully prepared you are, the less likely you will make mistakes later.
Basic preparation Finish. Leather treatment
For beginners, cutting leather You can use a silver pen, but if you have a little experience, it is not recommended to use a silver pen. Instead, use a sharp awl, scribe, etc. to trace the paper pattern on the leather.
< img src="https://img.111diy.com/timthumb.php?src=/d/file/p/73b6fdf76948c34a4f2f8c710e7cfc23.jpg" alt="">
Cut out the leather.
Use a edger or hot edge press to press out the leather on both sides Sideline.
< p style="text-align: center;">
In order to install hardware piece, so the two sides of the leather need to be thinned. When the paper pattern is folded, the thickness of the leather is almost the same as the whole.
Both ends of the short side need to be thinned, and one end of the long side needs to be thinned.
Punch holes in the buckle position.
Separately in leather Paste the fabric tape used for shoemaking on the inside to increase strength and extend life.
Install fasteners
Install hardware , it may be necessary to adjust the thinning thickness, etc. during the process, and then apply glue to bond.
After completion.
Crop and install The inner lining (lining) of the watch strap, size and length are based on the length of the installed hardware.
Finished handling the details , JiangliThe skin is bonded to the epidermis and then perforated.
Punched seams Line
Get started Ling cut, drilling along the sideline.
Perform edge sealing processing. There are many basic tutorials before edge sealing, so I won’t go into them here.
Twin-needle saddle stitch stitching.
Complete.
Watch strap
