Making a short clip wallet is a very detailed article, mainly focusing on thinning

It’s a very detailed article, mainly in a nutshell. If you like it, please give it a like and follow it, thank you! Main materials: cowhide, horse rein leather. Tools required: a mess. Production steps:

Let’s talk about the pattern first. What I made is 9.5*22, put 3cm on the outer skin, and the width. When drawing the pattern, draw 9.5 first, leave 0.5 inlays, and then three Each card position is 1.3, so the skin of the card position is 5.1cm, and then it is best to practice drawing it yourself. It is very helpful

Apply oil and let dry

The card position I made is 5.1*10. Use a ruler to cut both sides of the 1.3. You can also make beautiful seams. I Still prefer simplicity and roughness

Shrink 2cm from the bottom like this

< /p>In turn, thin the area

This is the base of the card position. Leave 2cm in the middle and 1.3cm at the top. Thin the following areas

Inlay thinning

Do not apply glue to the bed surface, but other areas must .

Family portrait< p style="text-align: center;">

Look at the thinning

Prepare together Edge sealing

card The upper edge of the seal and the inner side (as shown in the broken skin), a small section of the unglued lower side of the outer seal (10cm from both sides to the middle), the upper edge of the bottom seal plus the middle of the lower edge that is not thinned A paragraph.

Look To see the effect of 600 mesh, use the wooden stick again

Press decorative lines

Attach the first piece 1.3 inches from top to bottom. The middle seam must be aligned. If it is not straight, it will be ugly

Intrusion

Sew and then the second piece

Completed

The gap should be spanned Cut it, you can’t break it

< /p>Inserts are applied to the outer skin for three-dimensional fit

Use an awl to poke the alignment point

Using one tooth for corners is good

Come again

After finishing the work, the double-sided cutting is a very nice double wavy stitch

Apply glue, poke a few alignment points with a needle

Open the seam, distinguish the upper and lower needles, and it is easy to sew. Double wave

Come on

See if it is In this way, the thread goes up and down in the leather, which does not mean you are asked to sew like this

Rough grinding edge, edge sealing fluid 600-2000- Wooden stick, keep adding seam fluid during the process

Complete

Try tips for different colors, double-sided gluing and double-sided printing. Please add it to your favorites and follow it. I also have the motivation to keep doing it.

Short clip