French hemming experience sharing

Author: NPaiBB Weibo: https://weibo.com/u/2816163940

The steps shown in the French hemming method are purely personal habits and may not apply to everyone. Take a look at the renderings first

The thickness depends on personal habits, the thickness from left to right is 2.0, 1.2, 1.0 (take whatever you want)

The width and thickness of the edge leather strip are about 2cm 0.5, the length (length and width of the version Cut holes in the second circle of 4mm-5mm on the side, and the smaller hole is the back pad core.

First press out the inner ring and cut the seal. The advantage of hand-making is that the plasticity is greatly reduced and even errors can be avoided.

Effect

Mark out 2mm of the outer ring for glue ( That Italian water-based glue in Funanhe)

Thinen one end

Painted edge 2mm

Dry for a while

It’s long (don’t be too sparing with the shredded skin, feel free)

Cut the head and cover the other end of the overlap

Slowly hold the sticker

You can cut holes in the outer ring of the plate

Punch hole

Sutures

After sewing, turn it over and pinch it tightly

Other effect

Turn it over and apply glue, and pre-set the glue area

Let it dry a little, then stick it on all sides

Effect

Hammer, there is no need to teach you how to deal with these small wrinkles, this is the original French hemming Effect

Wide shovel Smooth out the overly convex parts and smooth the underside. You can also use vegetable tanning for this, as shown in the picture

The reverse side is the effect of vegetable tanning. This time I will change the chrome tanning method

Put off the convex part of the foreskin

It’s easy to make your own version, but the number of holes in this inner ring is exactly the same

Sewing the holes is done

Hemming