< /p>Apply glue on the flesh side of the decorative leather and the area where the outer skin of the bag was previously shaved, and then fit the decorative leather to the bag body according to the drawn positioning line. Cut and sew on the inside of the decorative line. After sewing is completed, Cut off the remainder of the decorative leather.
Cut off the remaining amount, sand it slightly, draw decorative lines and cut holes for later use.Draw decorative lines on both sides of the bottom of the bag and seal the edges. Draw a positioning line on the bottom of the outer skin of the bag, then shave it with a utility knife, and then connect it with the fleshy surface of the bottom skin of the bag Apply glue and fit them tightly according to the positioning line. Along theCut and sew on the inside of the decorative line. Create card slots inside the package . According to the drawing, punch the holes in the leather surface, and then stick the lining on the back of the leather in sequence. After attaching the inner surface, apply glue to the back of the card position and stick it securely. Cut off the surrounding margin according to the drawing layout. And draw decorative lines, cut and sew. Then apply edge oil and iron it with an edge ironing machine. Use 801 to peel around the inner skin Thin. Attach the card position to the endothelium according to the positioning, and then cut and suture. Choose the appropriate zipper length, clip off the excess teeth, and install the upper and lower stops. Sew the tail and zipper tail skin, make the zipper pull tab and install the zipper head. Zipper inner skin Draw positioning lines and then fold the edges. After the outer skin of the zipper is sealed with a decorative line and the inner skin is attached to the zipper according to the positioning, cut and sew along the inside of the decorative line, and sew the remaining ends at both ends. Cut to size.The inner and outer skin of the welt Cut the edges thin and apply glue to bend them. Cut off the excess at the top and press the decorative line to sew the edges.Draw a positioning line on the edge of the inner and outer skin and apply glue, and then stick it according to the positioning line. Then cut off the margin on the edge.Punch holes in the side leather and both sides of the bag body, and shave the areas that need to be bonded with a knife. First fit the side edge of one side to the body of the bag and sew it together. Then do the same with the other side. Use a knife to cut off the remainder and sandpaper to seal the edge.Both sides of the zipper leather Draw a positioning line and cut on the positioning line. The number of holes should be the same as the bag body. Shave the fitting area with a knife and sew after sticking. Cut off the remainder with a knife and sand the edges with sandpaper. The whole package is complete. Attached is a picture of the finished product
Handbag