Dandelion is a plant that represents purity, romance, and freedom. It looks like a fluffy ball and has a certain appreciation. However, the plush is easily blown away by the wind. Here I will teach you how to Handmade a dandelion resin , freeze the most beautiful moment and seal it in resin.
Material preparation: a dandelion, 502 glue, needle and syringe, plastic mold (available on a certain website), resin (crystal glue, AB glue, low viscosity), glue cup.
Squeeze the 502 glue into the syringe. Be careful not to get it on your hands during the process, as it will be difficult to wash off. Point the needle at the dandelion and drop 502 onto the plush.
First pour glue A into the cup, then pour glue B. The AB ratio is about 2:1, and then stir evenly. The glue will be turbid when first stirred, and then slowly become transparent with bubbles.
Soak the glue in warm water, just hotter than cold water, but not too hot. When the glue is a little hot, take it out and let it sit for a while. Put it in vertically and take it out. Do not let the glue touch the water vapor. When the fluidity of the glue becomes better, the bubbles inside will be squeezed out.
The glue needs to be heated for a few minutes. During the waiting time, you can trim the dandelion. When all the air bubbles are squeezed out, you can take it out for later use.
Then put the dandelion into the mold. After fixing the position, pour the glue along the stem of the dandelion. This step is more important and you must be more careful and pour it in slowly.
Don’t pour too much glue. Hold the stem and fix it for a while. When the glue becomes sticky, slowly lift up the stem and cut it off with scissors. Then the dandelion will sink a little and return to the shape it was in before you lifted it up.
The entire dandelion resin is now complete and can be taken out after the glue is completely set. The effect is as shown in the picture, you can also try making other plants.
