This is a simple leather clutch bag with a simple design that only uses a small metal stud for closure. If you also like this bag, I hope the step-by-step diagram below can help you, so that you can complete it by yourself through not too difficult efforts!~
First of all, of course, sketch the pattern.
Then make the shape on the cardboard according to the drawing.
Put the cardboard onto the leather to mark it.
Cut the leather according to the markings.
Bevel the edges.
Apply lubricant.
Polish.
Two holes are designed on the pattern.
Mark the leather as well.
Make two holes.
Put on the leather strips.
Sew into a closed loop on the back.
Use a lighter to burn it.
To start making the center band, I used a band cutter.
I cut a slash.
As shown in the picture after completion.
Apply polish to the edges.
Polished finish.
Place it on the bag as shown.
Sewing with the help of a sewing machine, you can also sew by hand.
The rubber edge area of ??the side panel.
Connect the edges first, then place in the center of the round base.
Make a side view of the bag.
This is where you add metal accessories.
Install 4mm studs.
Place the strap over the ring, place it into the stud seal and close.
The leather clutch is finished.
The effect after fastening the straps is amazing?!
