In previous issues, our production department editor introduced you how to make a small handmade bag. In this article, we will make a flip camera case bag for a digital camera. In fact, making handmade bags just requires a lot of patience, because it takes a long time. This DIY tutorial for making a camera flip bag is very detailed, and novices can also do it.
How to do it:
- You need to pay for the completed digital camera handmade package, the effect is as shown below.
- Prepare two pieces of fabric of the same size (front and lining). As shown in the red line in the picture below, leave a good sewing allowance.
- Sew the seam allowance about 1 cm from the seam allowance. (red line)
- Turn back to the "front" of the packet, the effect is as shown in the picture below.
- Put a digital camera on and try adjusting the small bag capacity. Mark the end of the crease with a pen according to your chosen depth. (yellow circle)
- Next, determine where the Velcro will go in the bag section. Fold the bag cover (black dotted line) and fix the position of the upper and lower Velcro.
- The expansion effect is shown in the figure below.
- Refold the markup attached in step "6" to "Inside Front".
- Refold at the mark (bottom of bag section) and make it into a "W" shape. (Picture fits "M")
- Place the digital camera and adjust the width. Sewing length 1cm at both ends (black lines). Slowly resize.
- Turn over the front of the packet. adjust size.
- Again, return to step "10". Sew narrower (red line). Sew about 1 cm in length from both directions.
- Also, determine the width again.
- Use a determined width (red line) to overlap.
- As the width is fixed and sewn, cut excess fabric.
- Turn it back to the front, next time determine the length of the lid and attach the seal (red circle). Also mark the relative positions of the Velcro staples that have been sewn.
- Sew Velcro tape on inner fabric only. (black line)
- Back to the previous "W" again. Turn the inner fabric towards you.
- Go back to step "16" and create a cap lengthof creases.
- Restore the crease to its original shape, take a 1.5cm seam allowance, and cut off the excess fabric.
- Fold quilting together. Shape the lid and sew (black lines). Sew on the side seam (red dotted line) seam.
- Cut excess seam width.
- Turn it back to the front starting from the unstitched area.
- The picture shows the effect of putting the lids together.
- The effect of sewing on the cover.
- Our handmade camera case bag is complete! oneThere is no trace of Velcro stitching at all. DIY tutorial for making a handmade camera flip bag. Have you learned it?
Extended reading:
1. Handmade fabric coin purse tutorial teaches you how to DIY a fabric purse
2. How to DIY cosmetic bag handmade fabric bag tutorial
3. Fabric handmade bag making tutorial teaches you how to DIY a small backpack
4. Fabric DIY super artistic Sakura mobile phone bag
5. Handmade home storage bag tutorial DIY fabric bow clutch bag