Detailed illustration of simple hand-knitted heart-shaped bracelet

Preparation tools:
A 125CM long flesh-colored embroidery thread (A thread)
A 85CM long red embroidery thread (B thread)
Glass glue
Scissors
I also need a 2-hole button. I forgot it when I took the photo.

1. After folding line A in half, tie a knot in line with line B at the bent place, leaving a circle The diameter should be at least large enough for a button to fit through.

2. Arrange the three wires at once according to the diagram (ABA) and use glass glue to fix the newly tied knot on the outer edge of the table according to the picture below. Be careful not to cover the knot with the glass glue.

3. Now move the rightmost thread away, and start knitting the remaining left A and B threads in your hand. Place left A on B, like a 4.

4. Then pass the left A through the two lines in the picture above and tighten it.

5. Tie this knot to the top.

6. Then place left A under line B, also forming a 4.

7. Then pass left A through the middle of the two ropes from above

8. Tighten similarly and tie the knot to the top. The above is the knitting method of the first row. The knitting method of the second row is the same as the first row, except that the B line is knitted up to the right A. I will not repeat it. In the end, the same knot is tied to the top.

9. Next, start editing the third row in the picture. Place line B on left A to form a 4.

10. B passes through the two wires Tie to the top.

11. Next, place line B under left A to form a reverse 4.

12. Pass the two threads through the same way and tie them to the top.

13. This is what it looks like after typing. At the end, there is only the fourth row left, which is the same as the first and second rows.

14. When the knitting is almost done, wrap the hand rope around your wrist and finish it at the desired position. The picture below shows the front.

The picture below shows the reverse side.

15. Braid the three threads to the end like a braid. I won’t explain this. If you don’t know how, I’ll forget it.

16. After braiding the braid, divide the three threads into two parts and pass them through a button hole respectively. Then tie the threads that come out through a knot and cut off the ends of the threads.