Home > Turning waste into treasure > bottle handmade

Illustration of how to make a homemade two-wheel rubber band powered car toy

Illustration of how to make a homemade two-wheel rubber band powered car toy

All you need to make a handmade rubber band powered toy car is two beer bottle caps and a little bit of paper! It only has two wheels, but it runs as fast as a rat, making it hard for your eyes to keep up! It’s simple and fun Bottle cap DIY, kids, take the time to try it!~

Materials and tools: two bottle caps, rubber bands, string, paper, tape, candles, nails, hammer, toothpicks, knife.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Use a hammer and nail to punch a hole in the center of the bottle cap.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Remember to place something underneath so as not to damage the table or floor.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Both beer bottle caps should be treated this way.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Take a piece of paper and cut out a long strip.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Then roll it up with a pencil.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Then take out the tape and stick it on.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Paping the entire paper tube together will not only fix it, but also look good.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Make it into a round straw shape about 5cm long.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Use a lighter to burn the blade.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Cut a small piece of candle and soften the sides.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Pull out the small piece of candle as shown in the picture.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Use a lighter to burn the tip of the nail and pierce the center of the candle to make a hole.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Get a candle like this.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Thread a string through a rubber band, hold both ends of the rubber band and pass it through the hole in a bottle cap. Place a small piece of toothpick to secure the rubber band to one side of the bottle cap.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Thread the string through the paper roll.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Pass the candle through the hole in the second bottle cap.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Pull the rubber band through the hole in the candle and place a toothpick on the end as well.

Illustration of how to make a homemade two-wheel rubber band powered car toy

NoteNote that the length of the toothpick on the side of one bottle cap should be smaller than the diameter of the bottle cap, and the toothpick on the other bottle cap should not be cut off.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Rotate the complete toothpick to create tension in the rubber band.

Illustration of how to make a homemade two-wheel rubber band powered car toy

Put it on the ground, let go, and it will start running under the action of the rubber band power system~