Use light bulbs to make beautiful handicrafts. Let the inside of the light bulb form its own space and put in a mini pirate ship. The method is not complicated. If you are interested, prepare the materials: light bulb, eraser (one large and one small), knife, a red and black gel pen, blue quartz sand, pins, toothpicks, glue, alcohol (for turning on the light bulb) , cardboard, needle-nose pliers, files and white cotton thread, let’s learn to do it~~~
There are two ways to open the light bulb: one is to wrap the tail of the light bulb with toilet paper, dip it in alcohol and ignite it for a few seconds and then put it in the water.
Another method is to use a small grinding wheel used to pull medicine bottles in the hospital, but it is not done well here.
Remove the complete bulb from the rear.
Get out your eraser and start making a pirate ship.
Cut out a boat shape on the large eraser.
After cutting, smooth it with a file.
Clip off the four pins.
Insert it on a small piece of rubber and place it at the stern of the boat.
Insert the pin to the bottom and secure it to the hull below.
Use toothpicks and pins to make the ships mast and prow post. In the picture below, the mast is on the left and the bow post is on the right.
Cut out sails and flags from cardboard and draw patterns.
Cut the upper part of the sail, punch holes in the lower part, and thread it through the pole.
Steps for installing sails and flags.
Made sails and flags.
Attach the sail and flag to the boat.
Use a pen to draw water lines, water holes, etc. on the hull.
At this point, the mini pirate ship is ready.
Pour glue and blue quartz sand into the bulb and mix evenly. If quartz sand is not available, blue chalk powder can be used instead.
After the quartz sand is dry, lower the mast.
Put it into the light bulb.
Put the mast up again.
Finally, put the tail of the light bulb back, glue it, and fix it to a base. The beautiful decorative ornament is completed.
Complete
