When you run out of toilet paper, don’t throw away the roll. It’s a good idea to use it to turn waste into treasure. For example, make a beautiful decorative flower and insert it into a glass vase. See the effect for yourself~~~
Material preparation:
Two toilet paper rolls (a flower); a hot glue gun; scissors; buttons; a piece of paper.
If you want to add a stem to the flower, you will also need the following materials:
28 gauge wire; wire cutters; paper bag
If you want to color, you need:
Pigment;Brush;
Material Handling:
Cut the first toilet paper roll along the center line.
Put the toilet paper rollCut the tube into four strips of equal width.
Cut off 1/2 inch from each of the four strips.
Cut the second roll along the center line, then cut it in half.
Cut all the rolling paper pieces into the shape in the last picture.
Make petals:
Dab a small amount of hot glue in the middle of a large piece of paper.
Fold another large piece of paper horizontally, press down and stick it firmly.
Turn the remaining two small pieces of paper 90 degrees and install them according to the direction of the previous step, continue to glue the small pieces of paper, and glue the button to the center of the flower.
Making the calyx:
Measure and make a mark 3 inches apart on a piece of paper.
Cut out the shape as shown in the picture. If you want them to have some curl, wrap them around a pencil to shape them.
Make flower stems:
Find a wire the length of which is a flowerThe stems are twice as long and peeled. Fold the wire in half and twist it a few times.
Bend the forked end to a 90-degree angle.
Cut a strip of paper from your paper bag.
Add a little hot glue to the end and wrap the paper tape around the wire. Start at the bottom and wrap it up to the bend just now.
Adhere the petals and leaves:
Turn your flower over and glue on a leaf. Turn the branched end of the stem downwards and bend it in the same direction as the cardboard.
Apply some hot melt glue to the curved section of the stem, turn the other leaf 90 degrees and glue it on top. You'll want to hold it for a while until the hot glue cools and hardens so the stems don't tip over.
Complete production:
