The folding method of Paperang paper airplane, the flying location was chosen on the fifth floor, about 15 meters high, and the wind force was level 2. The taxi was very stable. Due to the wind, it floated in the air for a long time before it stopped. To be honest, it was really refreshing to see the plane float in the air instead of landing on the ground!
The other side is the same as the previous part, and both sides can be synchronized.
Spread out.
The length to be cut is equal to 2x or slightly smaller than 2x, as shown below.
Then fold it in half according to the trace you just made.
Fold along the red line.
Fold the other side as well.
Then fold along this red line according to the method just now, and cut the 2x long opening.
Fold the other side as well.
Then cut along the red line.
Fold the small corner upward.
Fold the lower corners in the same direction as the upper corners.
Close.
Then spread out the two corners.
The entire aircraft unfolds.
The two corners are intertwined.
Linked.
When putting on the stapler, be sure to observe the left and right balance before pressing the stapler.
Both sides of the wings are slightly folded upward.
< /p>
Back.
The very stable Paperang paper airplane is folded. Take it to a high place and fly it. Pay attention to safety!
