There are many ways to fold a four-leaf clover. I have seen four-leaf cloverorigami before. The method is just made up of several pieces of paper. Is there any way to fold a four-leaf clover using just one piece of paper? Of course, today I will share with you how to fold a four-leaf clover from a piece of paper. If you are interested, come and learn it!
First fold out the two diagonals of the square
Fold the four corners toward the middle point just like we did when we were young, folding the four corners toward the middle point
Open it, then fold it to the drawn point, which is the intersection point you just folded, and press out the creases in all four corners
After folding, it turns purple
Continue with the above, fold it over and make creases along the opposite sides of the square. It will look like this after folding
After you're done, turn it back over and follow the picture I drew (its almost enough if you draw it randomly, the straight line is the peak line and the dotted line is the valley line, the same as mentioned before)
Like this
This is what it looks like after you put it away
These four pieces are leaves, and each piece is folded like this
ThisThere are already creases in the inside, here is a little trick, that is, there is no leaf like Jiang Zi, pinch it
After pinching, press down vertically, fold the four leaves in the same direction, and then fold out something like a small windmill
After folding, press it again in the opposite direction
Fold it and then stand it vertically
Press outwards
Tuck the four corners inward along the line
Fold off one-third of the leaves, each piece looks like this (according to preference)
Fold a small section on both sides of the leaf toward the middle, which is smaller than the middle one
Finally, use a knife or scissors to cut a little bit in the middle, up to half (can also be based on preference), and fold it to both sides
Okay, you can turn it over. Not bad~ It can be used for decoration~
