Todays recommendation These two hearts look a bit complicated. But, it’s still pretty good-looking.
Materials and tools required for heart-shaped origami:
A square piece of paper and scissors.
DIY three-dimensional heart-shaped origami instructions:
1. As shown in the picture, fold the creases of rice characters.
Then left and right sides The triangle is folded inward
Both sides go up Fold, make sure to align with the center line
Then, use Use your fingers to open the folded part and align it with the bottom edge to form a quadrilateral
As shown in the picture, Turn out two small triangles and fold them
The middle part should also be folded upward. Align to midpoint
Turn over, Repeat steps 3--step 6
Fold both sides After that, it looked like this.
Then, use scissors to cut the middle part.
After cutting, you can Fold out the protruding part. Front and back, left and right. Fold all four small tips.
Then, Turn the side of the heart over and press it flat.
Complete picture
Tips
Remember that the movements must be the same on both sides. Step 8 must be followed and must be cut.