Origami tutorial for Seraph Heart. The paper used is recommended to be 30×30cm hand-kneaded paper. Because the back is thicker, if you want to fold the wings, use A4 or rectangular paper with a length and width of 2:1. The steps are similar. The tutorial is very detailed, so I’ll skip the text if I don’t think it needs any more explanation~
2. Divide into eight equal parts and use squares for the six wings.
10. Turn over one piece.
11. Fold down (if you don’t understand these steps, you can read at the end for additional step instructions).
13. It is a fold in the middle of three triangles, turning it into a trapezoid.
14. Do the same on the other side and fold it into a 3-fork shape.
15. The other section is the same, folded symmetrically.
16. Fold in half and make creases.
18. Take this line as the axis of symmetry.
19. Fold the crease along the line, then fold it back.
20. Continue to make creases, crossing them with the creases from the previous step.
22. The left end is the same.
23. Fold back.
24. Fold back along the middle line.
25.Open back.
26. Repeat in the opposite direction.
27. The other end of the symmetry axis is the same and folded.
28. Fold in half up and down.
29.Open.
30. Fold both sides of the triangle with the middle line as the base.
31. Fold with the four sides of the square.
32. The left end is the same.
34. The two waists of an obtuse triangle with the middle line as the base are folded upward as the valley line.
35. Fold the middle diamond shape into a V shape.
36. The other side is the same and folded into a V shape.
37. Use the underlined part to fold, this can be adjusted by yourself.
38. Sinking.
40. Fold upwards by half the length of the height of the large triangle.
42. Open it to the left (fold the first piece of the right wing to the left), and fold it according to the peak line and valley line drawn in the picture.
43. Fold back according to the line in the previous picture and this is it.
44. Open it back and fold the second wing in the same way as the first one, and the same goes for the third wing.
46. The second wing.
47. Restore the first piece and that’s it.
48. The same goes for the third film.
50. Three wings restored.
51. Be careful not to be sloppy, fold carefully and delicately.
52. The back is origami. Remember, the protrusion of the lower end is very important and cannot be too small.
53. Turn it over, fold the left end in the same way, and the prototype is out.
54. Fold according to the drawn line segment. You can see clearly that it does not reach the edge.
56. Go back and fold down according to the line drawn above. It should not be too big or too small.
58. Expand and fold according to the drawn peak and valley lines.
61. Expand again and fold according to the drawn peak and valley segments.
63. Another one, the same folding method.
65. Restore the wing skeleton above, the first wing is OK, just like this (I posted the wrong picture here, it is the picture at the back, but it doesn't matter, they are all the same, just take a look at how the wings look like).
66. The same goes for the second wing.
67. The second wing is completed.
68. The same goes for the third film.
69. The third film is completed.
70. The right wing is completed.
71. The left end is folded symmetrically in the same way.
72. Start making the heart shape.
73. Fold according to the drawn line. This is your own control. Pay attention to the shape of the heart.
76. Fold the right and back sides in the same way.
77. Fold according to the drawn line.
80. Fold in.
82. Press well.
83. Looking back, I actually just folded the wings in a little bit.
84.This is the back.
85. This is what it looks like from the back.
86. In the same way, the other side is folded in the same way. This is the front side, don’t get it wrong.
87. Fold down according to the drawn valley line.
90. The same applies to the other three places.
91. Fold according to the drawn peak and valley line segments. You can control it yourself as long as it looks beautiful.
92. Just fold your wings closer.
93. The same goes for the right side.
94. Origami of Seraph Heart is completed!
Supplementary steps 11-13. Its actually very simple, just fold the middle one of the three triangles into a trapezoid.
