Home > Origami > Origami basics

Paper art rose making tutorial

Paper art rose making tutorial Paper art rose making tutorial

Roses made of paper vine

Main material: Various colored paper vines, white latex, double-sided tape, wires of two thicknesses, green plant tape, roll paper, silver glitter glue, Tools required: Scissors, ruler, small vise, small pen, Production steps:

Step 1: 1. Fold the rolling paper (double-layer 4 sheets) into three equal strips about 3.5cm wide (the width of the paper strip and the amount of rolling paper used can be adjusted appropriately according to the size of the flower). 2. Fold the wire in half, clamp one end of the paper strip on the wire, and roll it on the wire into a pagoda-shaped bud.

Paper art rose making tutorial

Step 2: Wrap the top of the bud with a small piece of paper vine in the same color as the flower.

Paper art rose making tutorial

Step 3: 1. Use thicker coated paper to cut out a petal template, and use paper vines to cut out a number of petals according to the template (the size and number of petals can be adjusted appropriately according to the size of the flower) 2. Use the back of the knife to scrape and bend each petal, use a thin bamboo needle to curl the top of each petal twice in a figure-eight shape, use your fingers to squeeze out pleats from both ends to the middle, and then open the pleats slightly.

Paper art rose making tutorial

Step 4: Apply glue to the bottom of the petals when attaching them (not too much)

Paper art rose making tutorial

Step 5: Apply the first layer of 2 processed petals to the bud

Paper art rose making tutorial

Step 6: Apply 3 petals on the second layer, making sure the petals are evenly spaced in steps

Paper art rose making tutorial

Step 7: Paste each petal on the outside of the bud in turn

Paper art rose making tutorial

Step 8: The petals should be evenly distributed and staggered. (Adjust the number of petals attached according to the size of the flower you want) until the size of the flower you want. Note: The top of the petals pasted at the back is equal to or slightly higher than the petals in front. Adjust the technique in time to ensure the perfect shape of the flower

Paper art rose making tutorial

Step 9: Cut the green paper vine into a 5cm×6cm rectangle (should be adjusted according to the size of the flower). Fold the cut rectangular paper rattan into six equal parts

Paper art rose making tutorial

Step 10: Cut into the shape as shown in the picture, unfold and cut off one piece.

Paper art rose making tutorial

Step 11: Use a rolling paper (singlelayer) into a paper strip about 1cm wide (the amount of rolling paper used can be adjusted appropriately according to the size of the flower), and the paper strip is rolled into a torus at the bottom of the flower.

Paper art rose making tutorial

Step 12: Wrap the cut green paper vine around the finished flower receptacle.

Paper art rose making tutorial

Step 13: 1. Cut the green paper vine into 2 rectangular pieces of 5cm×3.2 cm (the size of the leaves can be adjusted) 2. Paste a piece of double-sided tape about 5mm wide at 1/2, and stick the wire (the wire is about 5-10mm away from the top of the petal)

Paper art rose making tutorial

Step 14: 1. Use white latex to stick two layers of paper vines together, and then cut them into leaf shapes. 2. Cut out some small teeth on the edge of the cut leaves, and use green plant tape to combine the three leaves together. 3. Two sets of leaves can be made.

Paper art rose making tutorial

Step 15: Assemble the flowers and two sets of leaves

Paper art rose making tutorial

Origami basics:Paper art rose making tutorial