Home > Origami > Origami basics

paper art lilies

paper art lilies paper art lilies

Paper lilies made of various colored paper vines

Main material: Various colors of paper rattan, thick and thin iron wire, white latex, double-sided tape, Tools required: Scissors, ruler, vise, pen, colored pencils, Production steps:

Step 1: 1. Cut out 6 thin wires about 15cm long (to make stamens) and one thin wire about 20cm long (to make female stamens). pistil). 2. Wrap one end of each short wire with red vegetable tape for about 4cm, and then use white or yellow vegetable glue Then wrap the tape around 10cm, and use a vise to process the red part into the shape as shown in the picture.

paper art lilies

Step 2: Wrap the long iron wire with light green plant tape about 18cm, and use vise to process the top into the shape as shown in the picture.

paper art lilies

Step 3: Combine six stamens and one pistil. The pistil is about 1cm higher than the stamens.

paper art lilies

Step 4: Templates for petals and leaves: From left to right they are: Large and small petal templates, large and small leaf templates 1. Approximate size of large petals: 12.8cm×5cm 2. Small petal size: 11.8cm×4cm 3. Approximate size of large leaves: 11.3cm×3.5cm 4. The size of small leaves is about: 9cm×3cm

paper art lilies

Step 5: 1. Use paper vines to cut out 3 rectangles (double-layered) of suitable length and width according to the two petal templates, large and small. 2. As shown in the picture below, put double-sided tape in the middle of a layer of petals and stick the wire (note that the distance between the wire and the top of the petals is The distance is about 0.5cm-1cm).

paper art lilies

Step 6: Use white latex to stick the two layers of paper vines together, and cut out 3 large and small petals according to the template

paper art lilies

Step 7: Use colored pencils to process the lower part of the petals

paper art lilies

Step 8: Use the same method as the double-layer petals to make 4 large leaves and 1 small leaf

paper art lilies

Step 9: Use green plant tape to combine the 3 large petals and stamens. Pay attention to adjusting the 3 petals to the same height. The stamens of the stamens are approximately half of the large petals.

paper art lilies

Step 10: 1. Place 3 small petals in the gap between the first layer of large petals, and adjust the 3 small petals to the same height. 2. Assemble the flowers and leaves together to form a lily, starting with 1 small leaf and then two pairs of large leaves.

paper art lilies

Step 11: 1. Adjust the shape of each petal so that it curves downward naturally. 2. Arrange the shape of the stamens and adjust the shape of each leaf.

paper art lilies

Origami basics:paper art lilies