Electric car origami is novel and rare, simple and interesting, so fun

Electric vehicles are a daily means of transportation. This type of origami is not very common. Here, I will teach you how to fold an electric vehicle, or how to fold a scooter. The whole origami process is not complicated. Everyone Parents, do you feel that the kindergarten teacher’s homework has been completed? Haha, let’s start by following the steps.

1. Prepare a piece of paper with one color on one side and a cutting ratio of one to four. If there is no paper with one color on one side, it doesn’t matter. In this example, I used two pieces of paper of different colors stacked together; 2 , Fold it in the center as shown in the picture, and then fold it at both ends to initially look like the wheel; 3. Turn it over and fold both ends of the wheel in reverse; 4. Use the method in the picture to determine the approximate proportions of the front of the car body;

< /p>

5. After completing the above steps, make it look like this; 6. Fold the seam in the middle; 7. Lift the front of the car body, make it look like this and then compact it; 8. Fold it in the opposite direction, paying attention to the approximate proportions of the front of the car. Press out the crease;

< /p>

9. Expand it a little, and you can see the crease you just pressed; 10. Fold it as shown in the picture, and compact it; 11. Fold the front frame once in the opposite direction; 12. Fold it in the opposite direction again, as shown in the picture. Shown as the process of folding;

< /p>

13. After the front wheel is folded in reverse, compact it, and the faucet part is folded inward to create the shape of the faucet handlebar; 14. Fold the rear part of the body, and fold it upwards. Pay attention to the proportion. Basically, the length of the pedal is rear One-third of the upright structure; 15. Fold it down to make a crease, ensuring that the center of gravity of the rear wheel is roughly aligned with the bottom of the pedal, and then unfold it; 16. Fold inward along the crease in the previous step. And compacted;

17. As shown in the picture, fold the pedal outwards to create the shape of the pedal. Note that there is a continuation of the outward folding. The left side continues to the faucet and the right side continues to the seat; 18. The rear seat structure is unfolded; 19. Along the Follow the previous step, fold the rear seat structure inward and compact it, adjust the angle of the rear seat, and lift it up a little; 20. Detail the faucet part, fold out the handlebar part, fold the four sharp corners of the wheel inward, and process Make it into a circle, and a fun electric car is completed.

< /p>