Illustration of steps to make origami 3D car

Origami 3D car, this is a moderately difficult origami car tutorial. If you want to learn to fold a 3D car, then follow our illustrations on how to fold a 3D car!

Steps:

A. This is The front side of the paper.
B. This is the back of the paper.
1. From" 8x8 square" to start.
Make sure the back of the paper is facing up.
Turn the paper over.
2. Ensure paper There are 8x8 cells on the front.
3. Use current There are crease lines as installation fold lines to complete the four valley folds.
4. Complete here Crease pattern shown on the left.
5. Complete step 4 .
6. Complete here Two valley folds.
7. Put the paper flip over.
8. Outer edge Two valley folds are completed nearby.
Here you need to make two crease lines by completing two valley folds.
Make &Delta as small as 1/4 of the grid line.
9. Close both door.
10. Four Fold the mountain and pull the paper in the direction of the arrow.
11. Complete the steps Fold the four mountain folds of 10, and then pull the paper in the direction of the arrow.
Rotate the model 90 degrees.
12. This is the side view of the model.
Make sure you have the same form.

Rotate the model 90 degrees.
13. This is Top view of the model.
Make sure you have the same table.
Rotate the model 90 degrees clockwise.
14. Place the model Rotate vertically 90 degrees.
15. This is Origami car front view.
Work on the right side surrounded by the dotted ellipse.
16. Complete here Mountain folds.
17. In origami Working on the front left side of the car.
18. Complete here Mountain folds.
19. Complete the mountain fold in step 18.
20. Again Work on the right side.
21. On the right Work on side gain.
The mountain fold is completed here.
22.Also Work on the left side.
23. Complete here Mountain folds.
24. Origami The car model rotates 180 degrees.
25. Complete here Valley fold.
26. Start to complete Valley fold in step 24.
27. It might be a good idea to apply some glue on the outer edges.
28. Complete here Valley fold.
29. At this point, The work on the front of the origami car is finished.
Rotate the origami car model 90 degrees.
30. This is Same view from step 15.
Repeat steps 16-29.
31. Repeat the steps 16-29. Rotate the origami car model 90 degrees.
32. Origami The car model is rotated another 90 degrees.
33. This is Side view of origami car pattern.
Two mountain folds are completed here.
34. Origami The car model turns over.
35. Complete here Two mountain folds.
36. Origami The car is on the ground.
37. Okay !
You have completed the origami of the 3D car.