When I was a kid, I always had a dream of flying. I saw my neighbor’s little brother had a toy airplane. I liked it so much that I made one according to his look and shared it with everyone. My origami skills are not good, so I cannot fold a piece of paper to make a vivid airplane like the great masters. I just assembled the parts one by one. Don’t dislike the little plane I fly. If you like the little plane I made, give me a thumbs up! Thank you uncles and aunties! bend over!
Step 1: According to the front one, fold the A4 paper into the largest square. Please ignore the following. In order to match the other parts of the aircraft, the size of this square is 1:1.
Step 2: You need two, and bend your head. Glossy side outward.
Step 3: Cut off the corner on the big end side as shown in the picture.
Step 4:
Step 5: Fold out two cones with a size of 1:4. (That is, get a square that is one-fourth of the largest square on A4 paper), as shown in the picture.
Step 6:Then use a 1:4 square and fold it into two as shown.
Step 7: Now make the nose of the aircraft. 1:4 square paper, as shown in the figure, two in one. Cut off the long corner and insert it into the opening on the lower side.
Step 8: This is what it looks like after folding!
Step 9: Fold again, fold out the swallow’s mouth at the small corner, and cut off the swallow’s mouth. Also fold two.
Step 10: Fold it first, and then glue the two together. Two are needed.
Step 11: The aircraft parts are completed. Start assembling below.
Step 12:
Step 13:
Step 14:
Step 15:
Step 16:
Step 17:
< p>
Step 18:
Step 19: