DIY exquisite storage cabinet using cardboard waste

Using cardboard waste to make a DIY storage cabinet, look at the final product below, it looks pretty good. From now on, don’t just throw away the old things at home. You can reuse them and turn them into treasures! For specific instructions on how to DIY a cardboard storage cabinet, please refer to the detailed illustrated tutorial below.

The following is an introduction to the production process of one of the storage cabinets. In fact, making one storage cabinet does not save much work compared to making several at the same time.

Prepare the corn husks on the paper first, and use them later.

In general, I have the idea of ??a storage cabinet. When I make it, I can flexibly control it according to the materials.

The cardboard should be folded in half and glued, and the fold trace lines should be drawn first.

After the cardboards are all bonded, use a heavy object with a larger surface to press them up to make the cardboard flat and firm. The longer the better.

The shell is U-shaped, and the folding marks must be carved first. The sponge strips are glued on to make the folded corners stronger and the storage cabinet less likely to deform over time.

The following are the specific production steps.

Partitions must be accurately measured and consistent.

Glue one side of the storage cabinet first.

In this gap, make preparations.

Prepare the back panel of the storage cabinet.

You also need to press the back panel after it is glued.

Adhere the back panel.

Now that we are ready to make the drawers, we need to measure the dimensions first.

Several small drawers are unloaded together.

Draw the crease lines uniformly.

Start bonding.

Measure the dimensions of the base plate.

Cut out the base plate.

Apply glue.

After gluing the base plate, press it together for a while.

PressureAfter half a day, remove it and sand the corners with fine sandpaper.

Both sides need to be polished.

Install it and take a look.

Then, the corn batches prepared earlier came in handy.

Glue the panels carefully and make sure they are aligned beforehand.

When pressing, a piece of waste cardboard should be used inside the drawer to support it so that the force is even and the panel will be flat.

It’s still corn husks

Be sure to measure the center point when gluing the handle.

This is done to make the storage cabinet stronger.

Add a small piece of paper to the nail head so that the contents inside will not be scratched.

Its basically finished, whats missing?

Haha, the aluminum foil paper inside the cigarette box, cut a few strips and stick them on.

At the end, a finely crafted temporary storage cabinet is completed by hand!