Super detailed illustration of how to make a creative patchwork ruler lampshade for the harem

I often watch movies about harem women’s boudoirs on TV, and I see that the lights, table lamps and lighting inside are very warm and beautiful. So in fact, we can also make a poetic and romantic little harem through DIY! Let’s take a look below. There are a lot of DIY steps, so you must be patient.

Cutting 26 A piece of fabric larger than 1/4"-1/2" on the Dresden ruler. Among them, 13 pieces are used for the inner layer of the lampshade and 13 pieces are used for the outer layer of the lampshade.

Click what you like Put them in order.

Cutting 13 Block double-sided fusible paper (Pellon Peltex 72F Double-Sided Fusible Ultra FirmStabilizer), also needs to be larger than 1/4"-1/2".

Place the cloth pieces On the ironing board, back side up.

Put two Faced with fusible paper.

And then add Piece of fabric, right side up.

When ironing, place a damp cloth on top.

10 seconds Finally, remove the wet cloth and iron directly on the fabric.

Dress Place the patchwork ruler in the middle and cut the corners.

13 pieces of perfect fabric are made.

Setting up sewing Length 0mm, sewing width 4.5mm.

From the big end to The small end is used to sew, and the two pieces of fabric are sewn together.

If you feel it is not strong enough, you can sew it again.

Sewing thread Adjust according to fabric color.

6 pieces each Set, 7 pieces in a set are spliced ??separately.

The bottom of the lampshade is also Need to sew a circle.

Add ruffles to the bottom of the lampshade.

Ruffle Sew to the lampshade

Go to the second-hand market I purchased a cover about the same size as a lampshade and removed the old fabric, leaving the wire frame inside.

The lampshade is set on Wire racksuperior

Add hemming strips, pin fixation

Wrap the edges The strips, lampshade, and wire frame are hand-sewed together, as shown in the picture.

Turn the hemming strip to the front and hem it.

So far, beautiful The lampshade is finished.