The final version of the Buddhist bead bracelet—an illustration of how to tie the knot with the thre

We all know that there are many ways to tie knots. The following knotting method is called - the method of threading the three-way end. I hope it will be helpful to you! !
Lecture 1: - The end of threading the three-way tie
1. First, string the beads on the rope, and make the double thread of the rope stronger. Have two small steel wires or fishing lines ready.

2. Bend the end of a piece of steel wire. Prepare to thread the tee.

3. In this way, the steel wire can be smoothly penetrated into the triangular channel of the tee. likeIf it is a fishing line, you have to fold one in half and insert it in the middle, pass the other through the middle hole, pass the fishing line on the opposite side, then pull the middle fishing line, and pass the other end of the other line through the middle. Hole, just pull it and it will look like this.

4. Pass the stringed beads through the middle hole with another steel wire. Pay attention to the direction and look at the picture.

5. First, insert the open end of the string rope into the closed loop of the elastic cord you just pulled over, and then insert it into the closed loop of the steel wire. Pay attention to the order.

6. Another elastic linePull the end outward, stop after pulling it in halfway, and pull the steel wire upward (if it is a hand bead with a small hole like this, the rope is already quite tight when it is folded into four and passed through the hole. The method is very important. The steel wire is 0.4MM. Good, if it’s too thin it doesn’t have enough tension, and if it’s too thick it can’t be worn through. If it’s rough and has big holes, it’s easy to wear.)