Have you ever seen a hand rope with the shape below? It is actually a diamond knot rope, and the last part uses a figure eight knot. They are all entry-level knots, so if you want to knit the Chinese knot well, you need to tie it well. The basics are the most important. Some simple knots combined together will make beautiful accessories. Let’s make them together.
Materials needed: thread, scissors, lighter, beads
1. First, prepare the materials and tools we will use to weave the bracelet. The diameter of the wire is 0.08mm. There are five red strings and no limit to the number of beads. It’s best to choose red beads for easy wiring. Once ready, let’s start weaving. First, align the four red ropes of equal length, and tie the four together into a knot. Be careful not to tie them too tightly. Then place the red rope flat on the table, as shown in Figure 2
2. Start braiding the diamond knot. First, take any two threads on the side and place them as shown in Figure 1. Then make a circle with the thread above your finger, as shown in Figure 2. The circled If the thread does not move, loop the other thread from the bottom of the index finger through the upper loop, as shown in Figure 3, and tighten the first thread, as shown in Figure 4. After tightening, place the loop around your index finger on top and repeat the above steps.
3. Learn how to weave Vajra Knots skillfully, and keep knitting Vajra Knots. The length of the Vajra Knot is determined according to the size of the beads. I made 10 diamond knots. After braiding 10 pieces, put beads on the other two threads, as shown in Figure 2
4. Next, use two threads as one set of threads, and then start braiding the diamond knot from the two sets of threads, as shown in the picture. Note that four threads are used to braid the diamond knot at the same time. After braiding, the threads will be a little loose, and then you can sort them out a little. Try to make the two threads with beads as short as possible. I think it will look better. This is just a suggestion.
5. Repeat steps 2.3.4 and other steps, but pay attention to the direction. For example, the two threads used to weave the diamond knot for the first time will be strung with beads the second time. The directions are opposite, and the two threads used to string the beads will be opposite. The threads need to be braided into diamond knots, and then appear alternately until the length you want is braided. This is a partial picture of what I have braided, as shown in Figure 2 diyju.com
6. After editing, it’s the end. Prepare another wire first. Then arrange all the threads at both ends of the braided bracelet and put them together, as shown in Figure 2. Put the threads at one end to one side and the other end to the other side. Separate as much as possible. After straightening the thread, fold the other thread in half, and use the eight threads of the bracelet as the axis to make a flat knot. . After braiding, cut off the excess thread.
7. There are two ways to choose the remaining line at the end. No matter which one you choose, they all look good. One is to wear beads and string beads on the tail line. The second is braiding, braiding the figure eight knot, also known as the phoenix tail knot. The eight-character knot method is very simple and you can learn it once you learn it. I have shared it before, so I won’t go into details.
Extended reading:
1. Illustrated tutorial on how to weave a Chinese knot red bean knot bracelet
2. DIY tutorial illustration of red rope braiding dragonfly Chinese knot
3. Illustration of DIY hand-woven antique and elegant copper coin bracelet
4. Illustrated tutorial on how to weave Sansheng rope by hand
5. Illustrated tutorial on how to braid a four-thread hand rope
