A piece of rope can be turned into a beautiful bracelet through skillful weaving, which is comparable to turning waste into treasure. The following tutorial for weaving a diamond knot bracelet is suitable for novices learning the art of knotting. When weaving the bracelet, insert 3 beads to make it look less plain. Of course, you can also replace the diamond knot with a double knot or snake knot, etc. Friends, do you like this red rope bracelet? Follow the step-by-step diagram below and give it a try!~
Materials and tools: red rope about 70cm long, three 6mm beads, 1 tail bead, scissors, lighter.
1. Pick up the red rope, fold it in half, and start tying the diamond knot starting from about 30 cm.
2. The method of braiding the Vajra Knot is as shown above.
3. The diameter of the diamond knot should be controlled to be able to penetrate the tail bead. It depends on the material you are using.
4. Tie a diamond knot, gather the four threads, and then start to make a circular four-strand braid.
5. Measure the circumference of your hand, braid the four strands to half the length of your hand, and then start threading the beads.
6. Tie the two threads into a smooth knot, and use the two threads in the middle to thread the beads.
7. The other two threads are wrapped around the beads on the outside, and the thread passing through the beads is then tied with a flat knot to fix it.
8. Follow the same method and insert another bead.
9. Then insert the third bead.
10. Then continue to make a four-strand braid, braid it to the length of your hand, and then finish it with a diamond knot.
11. Put on the tail beads, tie a diamond knot to finish, leave 1 mm to cut off, and use a lighter to bake the remaining thread and press it flat with your hands.
12. The weaving of this red rope bracelet with beads is completed~
