—Illustration of how to tie the knot of the Buddhist bead bracelet through the three-way end.
Lecture 1: - The end of threading the three-way tie
1. First, string the beads on the rope, and make the double thread of the rope stronger. Have two small steel wires or fishing lines ready.
2. Bend a piece of steel wire. Prepare to thread the tee.
3. In this way, the steel wire can be smoothly penetrated into the triangular channel of the tee. If it is a fishing line, you have to fold one in half and insert it in the middle, pass the other through the middle hole, pass through the opposite fishing line, then pull the middle fishing line, and pass the other end of the other line through the middle. Hole, just pull it and it will look like this.
4. Pass the stringed beads through the middle hole with another steel wire. Pay attention to the direction and look at the picture.
5. First, insert the open end of the string rope into the closed loop of the elastic cord you just pulled over, and then insert it into the closed loop of the steel wire. Pay attention to the order.
6. Pull the other end of the elastic cord outward, stop it after pulling it in halfway, and pull it upward from the steel wire (if it is a hand bead with a small hole like this, fold the rope in half into four pieces and pass it through It is already quite tight when perforating. The method is very important. The 0.4MM steel wire is better. If it is too thin, the pulling force will not be enough, and if it is too thick, it will not be able to pass through. If it is a rough and large hole, it will be easy to pass through.)
7. Slowly pull out the elastic cord from the middle hole, and it’s basically OK
8. Put on the pagoda, hanging beads, and prepare to tie the knot.
Lecture 2: Tying a bow
1. First, align the rope into the following shape.
2. Tie the backward knot according to the direction in the picture.
3. When you start practicing, leave the rope head longer, as shown in the picture above, but it doesn’t look good when you tie it. When you formally tie the knot, adjust it to the following shape, and make the rope head shorter. pretty.
Four. Turn over. Hit it again in the same way.
Here is a little trick. This time, fold the longest end that is close to you first, and point it to the inside. Don’t pull it too tight. You will know the reason after folding it twice.
5. Now it looks like this.
6. Turn it over again, look at the four lines on the side pointed by the arrows, and pull them outward.
7. Use two hands together, pinch three thread ends each and pull them to both sides. Pay attention to the length adjustment.
8. Adjust the tightness and length and call it a day.
Lecture 3: How to tie a single-line tail knot (generally tied with disciple beads)
1. Look at the picture and tie a knot first, and then keep braiding.
2. After getting the style in the picture above, tighten it from the long line, as shown below. Then cut off the head and burn it with a lighter to call it a day.
