It is still difficult to knit the interface buckles of the bracelet. Here I will teach you the diagram of DIY bracelet knot tightness adjustment buckle knitting method. Lets learn together!
The tutorial is as follows:
1. Prepare two 30cm ropes. Use a lighter to burn the ends of the ropes at one end and then twist them into a sharp point with your fingers. The purpose is to easily insert smaller beads. Thread the beads as shown in the picture below, leaving appropriate distance.
2. Wrap the rope as shown in the picture below, and then tighten both ends of the rope.
3. The effect after tightening.
4. Wind the rope as shown in the picture.
5. Then wind it like this, and then tighten both ends of the rope. Don't pull it too tight, otherwise it will be more difficult to take the bracelet back and forth in the end. Boys' hands are stronger, and girls won't have this phenomenon.
6. Start winding the rope on the left first and then tighten it.
7. Wind the rope on the right as shown in the picture.
8. Wrap again, and then pull the two rope ends to both sides.
9. Repeat this action with the rope on the left.
10. Repeat this action with the rope on the right.
11. After going back and forth a few times, it is compiled like this. Be sure to remember the order, left - right - left - right, otherwise the braided look will not look good. Generally speaking, it is enough for the knot to be more than 1 centimeter after braiding. It will not look good if it is too long or too short.
12. Use scissors to cut off the excess rope, making sure to leave a slight 3-5 mm
13. Do you understand why a few millimeters are left? SmallHeart: Don’t burn it when it’s on fire.
14. The effect of rope end treatment
